· Clean the repair area on the car with cleaner.
· Start the glue melting heat gun part no. 13.977 (ready after 2 minutes)
· To choose the right hot melt glue sticks:
Part no. Colour Temperature
o 13.975 Yellow 12-25 degrees, lower temperature.
o 13.976 Blue 15-40 degrees.
o 13.979 Black 12-25 degrees, lower temperature
*Right glue sticks depending of the humanity and temperature.
· The air humanity can make it difficult to advice exact temperature for the glue sticks.
· Place the Glue stick in the started heat gun.
· Pickup the right red Plastic top
o (small, medium, large).
o Best success if the plastic top and dent are similar size.
· Ad the melted glue on the plastic top -then fast place the plastic top in the central area of the dent.
o Place the plastic top in the deepest area of the dent
o Make sure the plastic top is stable and 90 degrees on the repair area.
- · Wait 3-4 minutes. The glue has to be cold.
- · Place the Slide hammer in the top set and pull the dent up in right level with small steps.
- · Remove the glue with Glue Remover
- · Polish the repair after finishing.
Important:
· Repeat the repair process if needed.
· If the dent by an accident is too high knock down the top with a nylon tip.
· The temperature and the air humanity make the glue stick works differently.
Accessories to slide hammer system
13.990 Slide hammer
14.009 Glue remover 100ml.
13.975 Glue sticks yellow 15pcs.
13.976 Glue sticks blue 15pcs.
13.979 Glue sticks black 15pcs.
446-447-448 Knock down punch
13.991 Rubber hammer
14.003 Blue Tips plastic set Alu tips
14.0031 Round 16mm. 1405 Round 15mm
14.0032 Round 20mm. 1406 Round 20mm
14.0033 Round 32mm. 1407 Round 25mm
14.0034 Round 40mm. 1408 Round 30mm
14.0035 Oval 50x30mm.
13.974 TIDY Tips plastic set 14.002 Orange thin soft plastic set
Round 15mm. 14.0021 Round 30mm.
Round 20mm. 14.0022 Round 40mm.
Round 25mm. 14.0023 Oval 50x30mm.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.